Hp B Pdf User Manuals. View online or download Hp B Technical Data Manual. Items are supplied with manuals, accessories and typically a full no-quibble 2 year warranty. Our staff have extensive backgrounds in T&M, totalling over OPERATING AND SERVICE MANUAL PART NUMBER Instruments Covered by this Manual. HP Model A Signal Generator with .
|Published (Last):||11 September 2018|
|PDF File Size:||18.35 Mb|
|ePub File Size:||14.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
The suffix is different for each instrument. OdB absolute hval aacuracy in Pulse Mode. Ouput signal phase is adjustable in 1 degree increments. The input impedance is set to high impedance when the HP B is shipped. For each frequency measure the change in amplitude as the Mnual B is pulsed on and off. All front-panel annunciators and LED segments momentajily turn on for a visual inspection.
Hewlett-Packard B Signal Generator
Response to Clear Message. Table lists alternate test equipment that can be used. It is also assumed that you will supply whatever cables, connectors, and adapters are necessary.
Connect the digital multimeter to A10J2 pin 1. Unless otherwise stated the information applies to all three Signal Generators. The deviation displayed on the spectrum analyzer should decrease in relatively uniform steps.
Decreasing the frequency increment reactivates the key. Output Level Checks 8. Select FM with a peak deviation of 99 kHz using the internal 1 kHz source.
Switch off the Signal Generator and remove the power cable. Rack mounting information is provided vrfth the rack mounting kits. Frequency Amplitude Modulation 65 MHz. The amplitude variation from maximum to minimum should manuzl exceed 1 dB.
8656B Synthesized Signal Generator, 0.1 to 990 MHz
The Signal Generator remains addressed to listen until it receives an Abort message or a universal unlisten command from the controller. Use the [ recall! Press the CaKbr Process key. Comments Performing this feature: With the SWR bridge connected to the Signal Generator under test, and the amplitude of the RF signal source turned off, set a reference on the spectrum analyzer.
The 50 to MHz Notch Filters are de-sdected one at a time to pass that frequency.
HP 8656B Manuals
Step the amplitude down to -2 dBm. Center Frequency Deviation kHz 0. For warranty service or repair, this product must be returned to a service facility designated by HP. Adjust A4L25 for minimum spurious signals in the frequency range. The default display will be This section also includes User Confidence Tests.
HP HP Hhp Set the Signal Generator to the set-up you want.
DC Bp may be selected and entered along with any of the four ways mentioned in statements 1 to 4. FM distortion only applies at deviations up to 25 kHz for Connect the sensor module to the measuring receiver. Change the carrier frequency or the FM peak deviation to correct the error. Zero the measuring receiver and wait for the zero LED to go out.