This manual is proprietary to Brady Worldwide, Inc. and may be revised from time to .. The MINIMARK print driver is bundled with the Markware and higher. View and Download Brady MINIMARK user manual online. MINIMARK Label Maker pdf manual download. Brady MINIMARK Pdf User Manuals. View online or download Brady MINIMARK User Manual.
|Published (Last):||24 December 2012|
|PDF File Size:||9.29 Mb|
|ePub File Size:||2.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
Close the top cover and turn on the printer or press the feed button if 6. This device complies bady part 15 of the FCC Rules.
Brady MINIMARK Manuals
Parallel Interface Requirements 9. The Power Adapter has a barrel connector on one end that must be inserted into the power jack on the back of the btady. This manual is copyrighted with all rights reserved.
Supply the label roll out Label not installed. Keep pressing the feed button while turning on the power, until the one end, which is plugged into the mating serial port located on the back printing motor becomes activated. First snap in the right side and then the left side. Table of Contents Add to my manuals Add. Caring for Your Printer Comments to this Manuals Your Name. Windows is a trademark of the Microsoft Corporation.
Loading The Ribbon 4. Don’t have an account?
Enter text from picture: Any changes or modifications not expressly approved by the party. Check degrade printing quality. All brand or product names referenced in this manual are trademarks or registered.
Brady further assumes no liability. Table Of Contents If there is bdady item missing, contact your local dealer to get it. Unwrap the ribbon roll pack and separate the ribbon roll and the bare core. Turn the wheel of the print head module to ensure the ribbon is tightly wound.
First snap in the right side, then the left side. Power Switch Controls printer power 1.
MiniMark User Manual – MULTI
Brady disclaims all warranties of merchantability or fitness for a particular purpose. Operation of this mxnual in a residential area is likely to. Don’t show me this message again. In cutter On mode, the printer automatically cuts the label after it is printed 2 modes: Turn back the print head module and then insert the bare core into the pick-up holder. Hooking up the Printer and Computer The media guide can be click on each side.
Press down minimar print head module firmly on both sides till you hear a bent black plate with the other hand. Wheel Print Head Module 8. Reference Technical Information Operator Controls the printer is already on. Lead the label through the media guides and the cutter under the 6. Attach the edge of the ribbon on the bare core and wind it a little bit Release Levers onto the core. To print the manual completely, please, miinmark it.
Power Indicator Top Cover 2. Page of 14 Go. This section is not applicable to the direct thermal printing as Media Hanger a thermal ribbon is not required.
MiniMark User Manual – MULTI – Brady Europe
Lift the top cover to expose the media compartment. Insert the ribbon roll into the supply holder.
Loading The Media 3. Unlatch the print head module.
Technical Support – Brady Product Manuals
The port may be Label jam. Install the label roll Ports Select the correct port to link with the printer. Load the media roll onto the hanger.
This manual is proprietary to Brady Worldwide, Inc. Do not touch the heater element with your fingers. This equipment has miinmark tested and found to comply with the limits for a. Operation is subject to the. While every precaution has been taken in preparation of this document, Brady assumes no.