BreezeMAX Extreme is part of the carrier-class, field proven BreezeMAX product family and is the first wireless broadband solution to bring WiMAX 16e. BreezeMAX® Extreme WiMAX™ 16e pioneer for the license-exempt market WiMAX 16e for the License-exempt Market Main Features and Highlights. BreezeMAX Extreme is part of the carrier-class, field-proven BreezeMAX product family and brings WiMAX 16e technology to the 5 GHz license-exempt.
|Published (Last):||14 September 2012|
|PDF File Size:||15.69 Mb|
|ePub File Size:||12.79 Mb|
|Price:||Free* [*Free Regsitration Required]|
Aradial default installation of version 5. The value may range between 1. Please note, when downgrading from Release 1.
When running Spectrum Analyzer while operating in dual sector mode, if system had developed misssynchronization because of GPS breezemas, at the end of the scan process the system would reinitialize both channels. Upon successful completion the unit set automatically “run from shadow” and performs reset itself. It is important to design carefully the frequency allocations and potential bands e.
If static routes are added to a device acting as DHCP client the routed classes will not perform traffic. The breezemaz is auto recoverable and service is restored after few seconds.
Recovery actions in case BTS was upgraded to 1. When performing backhauling over Extreme CPE i.
Due wxtreme FCC regulation requirements, starting with release 1. The following is a general description: After link with BTS is established, the new version is Set as main automatically by the device For details on the required changes, please refer to the application note: One may need to implement timers or other logic scripts in the AAA to close these sessions.
No disclosure thereof shall be made to third parties without the express written permission of Alvarion. To refrain from unexpected network behavior it is recommended to set parameters to match the capabilities of the target downgrade version e.
When operating with DHCP option 66 and 67, the CPE might not receive an IP if option 67 is not used only 66 or if the option 67 xml file is not at the specified location.
Two service flows which have the same priority are equalized by the CPE at packet rates and not bit rates the packet sizes are not taken into account. Upgrade to Release 1. The GPS synchronization may take up to 30min when installing the base station in a new location, installer may refer to the GPS Menus as detailed in the system manual 5. Newly added with Release 1.
Note that these can be overcome with additional scripts and configuration of the default installed Radiator AAA: Under dual sector SISO base-station, running a spectrum analyzer on one sector may lead as part of the scanning to BTS restart affecting the operation of the second sector.
Specifically when operating a dual-carrier BTS e. Multi-host support behind a single CPE might not work. Recommended workaround is to minimize GPS holdover events — improving antenna installation location insure clear skyuse high gain profile antenna NE failure when provisioning a capacity limit CPE model with services sum exceeding the capacity limit. The Ethernet port supports only Auto Negotiation mode.
The material contained herein is proprietary, privileged, and confidential.
BreezeMAX® Extreme (BreezeMAX Extreme ) |
You may need to implement timers or other logic scripts in the AAA to close these sessions. This is mainly since IP address Base Station ID configured in each channel must be unique in the entire network. Such DSCP values might interfere with the brreezemax.
In order to downgrade to release 1. Such cases might occur when using limited license CPEs and the total number of services defined for such a CPE is above the licensed value. Upgrade also the CPE to Release 1. Network entry timeout prevent s full band scan in universal CC, thus workaround is needed to set only one BW to scan.
Update the Service Profile type per your extrreme e. It corresponds to bbreezemax versions: Alvarion reserves the right to alter the specifications in this publication without breeemax notice. When upgrading to release 1. CS to ensure management of the bridged BTS b. This service profile aims to optimize the air link performance attuned to the video content optimized for MPEG When connection with AAA is reestablished the entire cell will be authenticated again automatic de-registration of all CPE.
When using Optimized Video service, it is recommended not to use DSCP values of 1, 8 and 9 for uplink data traffic other than video. De-register the MS to have the new setting in affect Cases in which the CPE is presented as linked, even though it is not. When using forwarding with option 82, if the Service Group breezeamx is a Cisco router the following configuration must be add on the Cisco to permit the DHCP breezdmax to pass: Under GPS chaining, when there is a faulty chaining cable, the radio units in the chain may not initiate transmission.
Each manual covers all relevant topics associated with the respective equipment, including: