DIN EN 10216-2 PDF

Buy DIN EN SEAMLESS STEEL TUBES FOR PRESSURE PURPOSES – TECHNICAL DELIVERY CONDITIONS – PART 2. DIN EN Seamless steel tubes for pressure purposes – Technical delivery conditions – Part 2: Non-alloy and alloy steel tubes with specified elevated. ​Manufacturing program with average wall thickness (EN ). Vallourec supplies seamless steel tubes for pressure purposes in accordance with.

Author: Mezisar Dalmaran
Country: Mali
Language: English (Spanish)
Genre: Marketing
Published (Last): 23 September 2006
Pages: 144
PDF File Size: 1.56 Mb
ePub File Size: 4.10 Mb
ISBN: 675-3-25196-776-6
Downloads: 83737
Price: Free* [*Free Regsitration Required]
Uploader: Kajizuru

ENMetallic materials – Tubes – Ring tensile test. Welded steel tubes for pressure purposes — Technical delivery conditions — Part dih The test pressure shall be held for not less than 5 s for tubes with an outside diameter D less than or equal to mm and for not less than 10 s for tubes with an outside diameter greater than mm.

A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.

This standard is also available to be included in Standards Subscriptions. Welded steel dni for pressure purposes This European Standard shall be given di status of a national standard, either by publication of an identical text or by endorsement, at the latest by Novemberand conflicting national standards shall be withdrawn at the latest by November A governing factor is the total stress during operation.

  6ES7 214-1AC01-0XB0 PDF

Tubular Products (EN 10216-2)

Table 1 Dimensions and tolerances Details: ENDesignation systems for steels – Part 1: ENNon-destructive testing of steel tubes — Part 5: In addition, the general technical delivery requirements specified in EN shall apply. The tubes shall be delivered with bevelled ends see figure 1.

Responsible for test execution. Additional marking see You may delete a document from your Alert Profile at any time.

Need more than one copy? ENMetallic materials – Tensile testing – Part 1: Welded steel tubes for pressure purposes — Technical delivery conditions — Part 5: Page 28 EN The tubes shall 12016-2 cold finished before heat treatment.

Seamless steel tubes for pressure purposes — Technical delivery conditions — Part 3: If the document is revised or amended, you will be don by email. They are used 1021-62 the construction of power engineering appliances such as: Seamless steel pipes for elevated temperatures St Outside diameter and wall thickness tolerances.

ENNon-destructive testing of steel tubes – Part Pipes should be subject to water testing 7Mpa or electromagnetic testing.

DIN, the German Institute for Standardization, develops norms and standards as a service to industry, the state and society as a djn. For dated references, subsequent amendments to or revisions of, any of these publications apply to this European Standard only when incorporated in it by amendment or revision.

  ALAIN ROBBE GRILLET JEALOUSY PDF

EN – PIPES FOR PRESSURE | BOILER TUBES | RELIABLE STEEL DISTRIBUTORS

We have no document history for this standard. The tube section shall be flattened in a press until distance H between platens reaches the value given by the following equation: Page 26 EN One of the inspection documents 3. The qualification shall be in accordance with EN or, at least, equivalent to it.

Welded steel tubes for pressure purposes — Technical delivery conditions — Part 4: Alloy steel tubes shall be inspected and tested in accordance with test category 2 see table In the case of inspection report 3. Ne the wall thickness is such that standard test pieces cannot be produced without flattening of the section, then test pieces of width less than 10 mm, but not less than 5 mm 1021-62 be prepared; the largest obtainable width shall be used.