The Futaba GY Gyro was considered by most to be the best all round RC Helicopter gyro on the market FUTABA GY INSTRUCTION MANUAL. HKB is a gyro with function of dual rate and head lock, which designed for more prominent to use digital servo, It’s recommended that you use futaba Browse Futaba GY Gyro withSmm Technology owner’s manuals, user guides, instructional help documents & operating information to learn more about your.

Author: Dolkree Dusar
Country: Austria
Language: English (Spanish)
Genre: Life
Published (Last): 20 February 2015
Pages: 210
PDF File Size: 5.78 Mb
ePub File Size: 3.70 Mb
ISBN: 345-1-52215-907-7
Downloads: 61888
Price: Free* [*Free Regsitration Required]
Uploader: Yozshugore

For instance, do not fly the model. This servo boasts a speed of 0. Using the AVCS mode correctly. Gyro operation direction switch, DS mode ggyro, Control delay.

The Futaba GY401 Gyro

If you are not using a stock tail slider then use the other technique. On other gyros I would prefer to have Normal flight mode use standard rate because the HH mode mnual have a kinda jerky non-fluid motion when doing ground maneuvers such as slow piroueting circles. Do not disturb the trim in the radio.

For this setup we will futaga use the built-in gyro function. The gyro is normally used in this state.


FUTABA GY401 Instruction Manual

Procedures where the possibility of serious injury to the user is small, but there is a danger of. To print the manual completely, please, download it.

This value may be well below the point of “hunting”, but that is just fine. The ATV for the gain select channel has two sides. Wait 4 seconds for the gyro to initialize.

The signal side will be opposite of the black ground side. The GY followed the progress and that alone offered some nice value if you didn’t want to have to purchase another gyro for your next bird.

Therefore, if rudder mixing is ON, the model.

Futaba GY Gyro withSmm Technology User Manuals & Repair Guides – Fixya

The gain select futaha is plugged into any unoccupied slot in the receiver that has a corresponding switched channel on the transmitter. This will make the nose of the helicopter rotate to the right. To get the two Futaba connectors into your Spektrum receiver you will have to trim the flat piece that sticks out on the side. Take measures so that the gyro.

If the gyro peels, control will be lost. Miniature trimmers and switches are used with the GY to reduce its. Avcs gyro – yaw-axis stabilizer for model helicopter 43 pages.


In the AVCS mode, the servo does not return to the neutral position even. Without a doubt, the GY gyro with or servo is one of the best tail rotor stabilization systems produced to date. Lets take a look at this latest “SAFE” inspired version to help you decide if it’s worth adding to theā€¦.

Once the center of the ball link matches with the center of the ball and you have the 4. When operating the trimmers and switches, always use the miniature.


When the tail stops rotating, the servo. Again, watch the LED to confirm mwnual mode the gyro is in before making adjustments. Click Here For More Information. Then plug the 1 wire connector into channel 5 labeled ‘Gear’ – make sure the yellow wire is on the signal side.

When you want to. On a Futaba receiver, this is channel number 4. The cushioning is done inside the gyro.