Honda outboard service/repair manual – Seloc | 4-stroke | 4 stroke | Table of Contents PDF file | 2 hp – hp – 4 hp – 8 hp – 40 hp – 50 hp – 75 . Clymer Honda Outboard Marine service and repair manuals are written with model specific coverage for your Honda Outboard Marine. From basic service and. View and Download Honda Outboard Motor BFA owner’s manual online. Honda Power Equipment Outboard Motor Owner’s Manual. Outboard Motor.

Author: Gagul Kazimi
Country: Panama
Language: English (Spanish)
Genre: Environment
Published (Last): 3 January 2011
Pages: 173
PDF File Size: 4.25 Mb
ePub File Size: 16.68 Mb
ISBN: 765-7-33994-623-7
Downloads: 21327
Price: Free* [*Free Regsitration Required]
Uploader: Kazrarisar

Overheat Indicator Comes On And Engine Speed Is Limited If the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer.

By pressing ‘print’ button you will print only current page.

Improperly maintaining this outboard motor, or failure to correct a problem before operation, can cause a malfunction in which you could be seriously hurt or killed. The engine will not start if the F forward or R reverse gears are engaged. Remove and inspect spark plugs. Outboard Motor Safety Understand the use of all controls. Replace the anodes when they have been reduced to about half their original size, or if they are crumbling. Refuel outdoors, in a well- ventilated area, with the engine stopped.

After the outboard motor is placed in storage and disconnected from the owenrs, install the engine cover. If the engine fails to start within 5 seconds, release the key and wait at least 10 seconds before operating the starter again. Never refill the fuel tank inside a building where gasoline fumes may reach flames or sparks.

Owner’s Manuals

This shows that water is circulating through the cooling system. Tachometer optional Equipment The tachometer shows engine speed in revolutions per minute.


Shallow Water Operation LAUNCHING To raise the outboard motor out of the water while the engine is stopped and the boat is moored, or for maximum clearance when beaching or launching, use the hondw tilt switch on the engine pan to tilt the Remove the two mud guard clips from the upper part of the under cover grommet. Disconnect the ownerz motor from the boat, hoist the outboard motor, and move it to the storage area. Power Tilt Switch The tilt lock lever is used to support the outboard motor mahual the fully-raised position.

Possible Cause Fast idle lever raised side-mount type. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

These mnaual are considered permanent parts of your outboard motor. Panel-mount Type The emergency stop switch clip and lanyard system is a safety device that will outboare the engine if you fall away from the controls while operating the boat. Page Problems That May Af f ect Emissions If you are aware of any of the following symptoms, have your engine inspected and repaired by your servicing dealer. To meet clean air standards, some areas of the United States and Canada use oxygenated fuels to help reduce emissions.

It will also help reduce air pollution. Please read them carefully. And using this outboard motor safely is an important responsibility. These gasolines are collectively referred to as manuao fuels. It may also damage metal, rubber, and plastic parts of your fuel system. Damage to the power tilt system may occur.

Propeller Replacement Before replacing the propeller, remove the clip from the engine stop switch to prevent any possibility of the engine being started while you are working with the propeller. Stop hinda engine immediately if anyone falls overboard, and do not run the engine while the boat is near anyone in the water. Fuel hose not primed.



Starting The Engine The emergency stop switch clip and lanyard system is a safety device that will stop the engine if you fall away from the outbboard while operating the boat. Fast idle lever raised side-mount type. If your tool kit needs replacement, it is not available as a kit and each item must be ordered individually. Never smoke near gasoline, and keep other flames and sparks away.

Handle fuel only outdoors.

The control lever cannot be moved away from the N neutral position unless the fast idle lever is lowered. Possible Cause Out of fuel.

You can be burned or seriously injured when handling fuel. If a label comes off or becomes hard to read, contact an authorized Honda Marine servicing dealer for a replacement. Wipe up spills immediately. Enter text from picture: Refuel carefully to avoid spilling fuel. Clean the oil filter mounting base, and coat the rubber seal of the new oil filter ohnda clean engine oil.

Fuel filter or fuel tank filter clogged. Bad fuel; boat stored without treating or draining gasoline, or refueled with bad fuel. Page 96 If there is still no water flowing from the cooling system indicator, or if the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer.