IEC Standard | Switches for appliances – Part Requirements for mechanical switches. This part of IEC applies to switches for appliances. The switches are intended to control electrical appliances and other equipment for. This part of IEC applies to electronic switching devices and shall be used in conjunction with the general requirements of IEC
| Author: | Yozshumi Taran |
| Country: | Malaysia |
| Language: | English (Spanish) |
| Genre: | Technology |
| Published (Last): | 24 February 2015 |
| Pages: | 427 |
| PDF File Size: | 7.17 Mb |
| ePub File Size: | 12.66 Mb |
| ISBN: | 353-7-42871-159-7 |
| Downloads: | 52720 |
| Price: | Free* [*Free Regsitration Required] |
| Uploader: | Malak |
The method of operation is that specified for accelerated speed in Amendments [ssued Since Publication Amend No.
Throughout the electrical endurance test, the auxiliary switch A is open-circuited. Unique Type Reference, U.
BS EN 61058-1:2002+A2:2008
Immedmtely after the appropriate test, the switch shall withstand the dielectric strength test specified in The Intended mfithodfs of mountitiy and the Intended oriGnla! Already Subscribed to this document.
Detachable parts are removed. Protection against overvoltage — Section Measurement of creepage distance is from screw to wa.
Your Alert Profile lists the documents that will be monitored. Protection against electric shock 2 Amendment 1 Amendment 2 lEC Where this is not practical on the iecc to be used for the test of clauses 16 and 17, the test of Proceed to Checkout Continue Shopping.
After these tests, the switch shall stilt comply with the requirements of clauses 9, 13, 15 and Protection for safety – Chapter General requirements lEC Testing and measurement techniques – 610558-1 4: For the following tests the electronic switch Is mounted as in normal use and is loaded as specified in clause 17 so that at the rated voltage the rated load will be obtained.
Coating can be varnish, a dry film applied to the printed board or can be 6158-1 by thermal deposition NOTE Coating and base matertal of the printed board form an insulating system that may have properties similar to solid Insulation 3.
IS/IEC 61058-1: Switches for appliances, Part 1: General requirements
If a switch is delivered without an actuating member, then a suitable actuating member should be supplied by the manufacturer for the purpose of this test; f for accelerated speed: Amazon Restaurants Food delivery from local restaurants. Guide to the dimensional limits of circular conductors lEC You 611058-1 experience ifc viewing this site in Internet Explorer 9, 10 or Smaller clearances than those specified In table 22 are not allowed.
The electrical conditions are those specified in 17 2 1 The method of operation is that specified for high speed in Find Similar Items This product falls into the following categories.
Compliance is ctiecked by measurement. For switches with electronic actuating members, actuation shall be performed according to the manufacturer’s declarations.
UL – Switches for Appliances – Part 1: General Requirements | Standards Catalog
Your basket is empty. The operating speed for the operating cycles shall be as follows: Resistive current, peak surge current, voltage and nature of supply may be indicated accordingly as follows: Cable inlet openings, if any, and drain-holes are left open. I’d like to read this book on Kindle Don’t have a Kindle? During the measurements, each one of the resistors and all other components, if any.
If it has more than one polo, it may be called “multipolo” two-poie, three-pole, etc provided that the poles are coupled 6105-81 such a manner as to Operate together 3,1. Supplementary requirements for fuses for use by unskilled persons fuses mainly for household and similar applications – Sections I to IV EC