ISO was prepared by Technical Committee ISO/TC 35, Paints and .. The test panels shall be dry and free of dust and any other foreign. ISO (E) ISO. Second edition. Paints and varnishes — Performance This is a free 6 page sample. Access the full version . Reference number. ISO (E) ISO. First edition. Paints and varnishes — Performance This is a free 6 page sample. Access.
|Published (Last):||18 April 2012|
|PDF File Size:||16.49 Mb|
|ePub File Size:||5.18 Mb|
|Price:||Free* [*Free Regsitration Required]|
ISO environmental testing servicesAccelerated Weathering Laboratory
The product shall be applied within its shelf life. Each member body interested in a fref for which a technical committee has been established has the right to be represented on that committee.
In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. Dimensions jso millimetres Key 1 2-mm-wide scribe line 2 0,mm-wide scribe line Figure 1 — Test panel showing position of each type of scribe line????? Many other additional tests could be useful in characterizing more precisely the components of a paint.
ISOIron oxide pigments for paints  Micaceous iron oxide: ISOMicaceous iron oxide pigments for paints fere Specifications and test methods  Zinc dust: An example of a paint system template is given in Table 2.
Deviations from the over-coating time specified by the paint manufacturer shall be agreed between the interested parties and recorded in the test report. In downloading this file, 2040 accept therein the responsibility of not infringing Adobe’s licensing policy.
The actual test or tests to be carried out shall be agreed between fre interested parties. At least the following information shall be shown on the label: Adobe is a trademark of Adobe Systems Incorporated.
An example of fingerprint testing is given in Annex B. Unless otherwise specified, no lso of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s member body in the country of the requester.
The paint manufacturer shall carry out routine batch testing on each batch of paint.
It should be emphasized that the paint systems given in Table 3 are made up of different generic types of intermediate-coat paint and topcoat paint. If changed, the paint system is subject to re-qualification as agreed between the interested parties.
Table 3 is not intended to be comprehensive, nor is the intention that it be used as specification guidelines. Each of the parties involved shall be entitled to carry out additional checks on any batch to verify the fingerprint.
Alternative procedure without low-temperature exposure If specified, an alternative exposure cycle may be used. Assessment after water immersion 4 h Panel No. In order to establish sufficient corrosion protection and ensure optimum performance of the coating, it is necessary to specify the requirements for the protection paint system s along with the relevant laboratory performance tests to assess its their likely durability.
In ISOrelevant requirements are given for the following: For twin-pack materials, the pot life shall not be exceeded.
Only new work and any repairs necessary before start-up are included. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. Surface preparation Length, width and thickness: Specifications vree definitions for ISO surface profile comparators for the assessment of abrasive blast-cleaned surfaces ISO The structure may be divided into four zones based on the type of environment each zone is exposed to: Every care has been taken to ensure that the file is rfee for use by ISO member bodies.
Table 3 —Typical examples of some protective paint systems and their initial performance Substrate Blast-cleaned carbon steel: Optional tests may also be carried out, such as impact resistance, abrasion resistance and 02340 resistance. Table 2 — Example of a paint system description Manufacturer Type of substrate Type of environment Name: Such information, and the detailed results of the assessment process, shall be the property of the purchaser but shall not be disseminated by the purchaser without prior agreement from the paint manufacturer.
For undated references, the latest edition of the referenced document including any amendments applies.